In the principle of screw plasticization, single-screw extruders operate on a drag-flow mechanism: the screw provides forward lateral force, creating a velocity gradient between the powder and the barrel, which results in weak friction. Therefore, external heating becomes crucial. Recently, while calibrating a rheometer, we encountered an issue with a specific high-filler formula. Using the same powder preparation process, we added 70 grams of dry mix, but even after 6 minutes of testing, the material remained completely unplasticized. Increasing the temperature to 200°C or adjusting the formula didn't help much. However, when we added 80 grams of dry mix, plasticization occurred, and with 85 grams, the process was even faster.
This observation triggered a sense of déjà vu, though the issue was quickly resolved and soon forgotten.
It wasn't until someone reported a similar issue with conical twin-screw extrusion-where the material wouldn't plasticize initially and then suddenly overflowed once it did-that I recalled encountering this situation multiple times before. This occurred with both 65mm and 55mm conical twin-screw machines, where insufficient feed ratios caused resin flow visible through the vacuum port. The plasticization process seemed to reverse, starting from the die and extending backward. When it reached the vacuum port, the material would overflow. Even raising the machine temperature to 230°C only slightly improved the situation, but PVC degradation accelerated. Only by increasing the feed ratio to an appropriate level did plasticization proceed normally. However, due to significant wear on the screw's front end, backflow increased, causing material overflow at the vacuum port. Adjusting the formula to enhance initial plasticization offered some improvement.
This entire scenario highlights that PVC extrusion requires proper pressure or mold-filling conditions for successful processing; temperature adjustments alone mainly serve to modify melt flow characteristics.
So, which factor plays a more significant role in plasticization-temperature, formulation, or shear force?
Mechanical shear force. The "Plastics Industry Handbook" on PVC clearly states that the plasticization of general-purpose suspension PVC, or the optimal primary particle flow for plasticization, is achieved under high uniform shear conditions, which cannot be attained by temperature alone. This means that while formulation adjustments can partially optimize the process, the core factor remains the shear force provided by the equipment. This has been consistently verified. Even when using the same raw materials, formulations, and molds from KraussMaffei, different equipment produced products with inconsistent notch impact strengths, failing to consistently achieve values above 30 MPa.

